SpectraLink Link 150, Инструкция по установке и эксплуатации

Страница: 30 / 89

SpectraLink Link 150 Installation and Operation
12/28/98 22
All lines are unregistered when shipped from the factory. However, if you are replacing a
failed MCU you may not need to register the wireless telephones. Refer to 8. System
Administration for details.
Line 1 MCU 1 should be skipped to allow for remote access through the
diagnostic modem.
Each MCU supports eight simultaneous conversations. To optimize
performance and reduce the possibility of call blocking, distribute the wireless
telephones evenly across all MCUs.
To register a wireless telephone to your system do the following:
1. Make sure all unregistered wireless telephones are powered off.
2. Move the mode switch to the REGISTER position. (If your system has more than
one MCU, be sure to move the switch on the correct MCU.) The box ID may
change. This is normal and is not an error.
The Line Indicator LEDs now show the registration status of each line.
−
If the LED is on, a wireless telephone is registered to the line.
−
If the LED is off, no wireless telephone is registered to the line.
3. Press the
STEP
button until the LED for the line to be registered flashes.
−
If the LED is flashing red, that line is selected. A flash with the LED
mainly off indicates no wireless telephone registered; a flash with the LED
mainly on indicates a wireless telephone is registered to the selected line.
−
Initially Line 2 will flash. This is because Line 1 is usually set up as the
remote access diagnostic modem. To register a wireless telephone to Line
1, press the STEP button until Line 1 flashes.
−
If the desired line already has a wireless telephone registered to it, follow
the procedure outlined below to unregister the wireless telephone, then
return to this step.
4. Turn on the wireless telephone to be registered by holding down the
PWR
key
until the wireless telephone beeps twice. The line indicator LED on the MCU will
shine solid red. Once the wireless telephone is registered, the LED for the next
unregistered line begins to flash.
5. To assign the wireless telephone's extension number, hold down the FCN key, and
press the
# >
key (NEXT) until
EXTENSION
displays on the wireless telephone.
Enter the extension on the wireless telephone keypad, then press
END
.
6. Repeat steps 3-5 for all wireless telephones to be registered.
7. When all wireless telephones are registered, return the mode switch to the NORM
position.