Specac Atlas Automatic 40 Ton, Руководство пользователя

Страница: 58 / 68

User Manual
56
Cause C: There is air trapped in the pumping system.
Remedy: Fill oil reservoir to correct level with the piston cylinder fully
retracted and proceed to bleed any air in the oil out of the
system using the Oil Bleed Kit of parts P/N GS25490 – Press
Service Procedure 2S-25490-1.
Cause D: There is a leak pass the “Dowty” seal on the manifold block.
Remedy: Contact Specac and give serial number of press. Replace
the Dowty seal for the Atlas Power Press using the Dowty
Seal Kit of parts P/N GS25493 – Press Service Procedure
2S-25493-1.
Cause E: Pressure relief valve dirty or damaged.
Remedy: Contact Specac and give serial number of press.
Cause F: Motor/pump damaged or worn out.
Remedy: Contact Specac and give serial number of press. Replace
the motor/pump assembly for the Atlas Power Press using
the Motor/Pump Assembly Kit of parts P/N GS25492 – Press
Service Procedure 2S-25492-1.
Fault 7: Pressing Piston will not retract.
Cause A: The program running on the press has become “confused”.
Remedy: Power down the press (switch off ( 1 )) and then re-power the
press (switch on ( 1 )).
Cause B: An internal fuse has blown.
Remedy: Contact Specac and give serial number of press. Replace
the fuse for the Atlas Power Press from the Replacement
Fuse Kit of parts P/N GS25494 - Press Service Procedure
2S-25494-1.
Fault 8: Creaking sound when load being applied and released.
Cause: Friction movement of compression spring rings.
Remedy: Contact Specac and give serial number of press. Lubricate
the compression spring rings for the Atlas Power Press from
the Compression Spring Ring Lubrication Kit P/N GS25495 –
Press Service Procedure 2S-25495-1.