Specac Atlas Automatic 40 Ton, Руководство пользователя

Страница: 55 / 68

Atlas™ Auto 40T Hydraulic Press
53
8. Fault Finding, Causes and Remedy for
Atlas™ Auto 40T Press
The Atlas™ Auto 40T Hydraulic Press should give years of trouble free
operation, if used and cared for correctly. If there is a failure of the
press operation, it is recommended that you contact your local Specac
representative immediately, particularly if your press is still within a
warranty period of usage. It will be a requirement to identify your press
from its unique serial number found on the appliance label at the rear
of the press and provide a brief and clear description of the fault. For
technical faults Specac may be contacted via email at
techsupport@specac.co.uk.
However, some faults that may develop can be identified and fixed
without the potential need for return of the press to Specac. The
following information is provided to identify some faults and carry out
the necessary repairs and adjustments should you decide to do so.
Fault 1: There is no power to the press when the on/off power
switch (1) is pressed on but power from a mains
connection has been established.
Cause: The mains fuse ( 19 ) is broken or damaged.
Remedy: Replace the mains fuse with the appropriate current
(amperage) type for both 220 volts and 110 volts mains operation. The
fuse is located within the mains fuse holder (
19 ) at the rear of the
press. (See Page 15.) The fuse holder is a slot screw, push in and
turn, spring release type. The fuse to use is a 32mm long, 5amp, anti-
surge type (P/N 254-072).
FOR SAFETY, DISCONNECT THE PRESS
FROM A MAINS POWER SUPPLY BEFORE REMOVING THE FUSE.
If the fault still persists when a new fuse has been replaced, please
contact Specac for further advice.
Fault 2: The motor/pump does not run when the start/apply load
button (13) is pushed.
Cause: The press front safety guard ( 5 ) is still open.
Remedy: Fully close the front safety guard ( 5 ).