18 von 36
Service record Dynamis MV
Service record Dynamis MV
2021-01-12
3.5.3 Adjusting the height
1. Remove the screws
(A)
on the journal part,
2. Adjust the height as desired by lifting and
3. Insert the screws again, tighten them and
then check them.
The height of the legrest can be adjusted by
1.5 or 3 cm. To do this, please follow the steps
below:
(A)
3.5.4 Preset opening angle
The opening angle of the legrest can be adjus-
ted continuously between 90 ° and 117 ° via a
presetting as follows:
1. Engage the pull latch with a 90 ° turn
(A)
2. Loosen the screws
(B)
on the grid plate on
both sides, inside and outside.
3. Adjust the legrest to the desired position.
4. Tighten the screws again firmly.
(A)
(B)
3.5.5 Height adjustment of the calf support
To change the height of the calf support, ple-
ase follow the steps below:
1. Loosen the screws.
(1A)
2. Now move the calf clamping plate and at-
tach the removed elements in reverse order.
3. Make sure that all screws are properly tigh-
tened.
(A)
(1)
Height adjustment not possible in combination with an abduction wedge.
(1)
(1)
