Service record Dynamis MV
11 von 36
2021-01-12
3.1 Wheels assembly
(1)
(D)
(B)
inside
out-
side
Check / correct the distance between the drive
wheel and the side panel or the clothes guard by
attaching the drive wheel.
The tires on the bike must be at least 10 mm away
from the side panel or the clothing guard. Pay
attention to the same distance left and right!
(1)
For turning the quick-release axle fitting in or
out:
•
Loosen the screw connection of the fitting
(B)
(also the lock nut on the inside),
•
turn the complete fitting
(C)
into the re-
quired position and
• Tighten all screw connections again (tigh-
tening torque of nuts M18 fitting 40 Nm).
Be sure to check the functionality of the knee lever brake and readjust it if necessary.
3.1.7 Track compensation drive wheels
The wheelchair is delivered with the appropriate toe-in, depending on the camber setting and
any installation of the SORG outdoor front end. When changing the camber or retrofitting the
outdoor front end, it may be necessary to change the toe-in.
To change the toe-in:
• Remove drive wheels,
• and remove screw connection
(B+C)
.
Depending on the attachment variant and the
camber, please follow the instructions on the
following pages.
(A) (B)
(C)
(2)
After changing the toe-in settings:
• reinsert the screw connection
(B + C)
and tighten the screws
(B)
tightly.
Check / correct the distance between the drive
wheel and the side panel or the clothes guard
by attaching the drive wheel.
Be sure to check the functionality of the knee lever brake and readjust it if necessary.
