10 von 36
Service record Dynamis MV
Service record Dynamis MV
2021-01-12
3.1 Wheels assembly
• (1)
Remove the caps on both sides
(A)
,
• remove all screws on both sides
(B)
• and remove the spacers if necessary.
• Replace the caster wheel adapters with
new ones and / or move them to the
alternative holes
(C)
.
• Reinsert all screws (including the spa-
cers, if applicable) and tighten them
tightly.
3.1.5 Replacement / relocation of the steering wheel adapters and caster wheels
(1)
(A)
(B)
(C)
You influence through the camber:
• the lateral tipping stability
• the shoulder drive wheel position and
• the track width of the wheelchair.
(2)
To avoid the so-called "eraser effect", we install
the appropriate track compensation
(A)
at the
factory. If the camber is changed at a later date,
the toe compensation adapter
(A)
must be repla-
ced with a suitable one (spare part).
With a wheel camber of 8 °, a spacer block is re-
quired to extend the wheelbase (spare part).
Adjust the camber:
• (3)
Remove drive wheels,
• Remove the screw connection
(A)
and
move it into the alternative holes
(B)
,
• tighten the screw connection again.
For a camber of 8 °:
• (3+1 next page)
remove the screw con-
nection
(A)
,
• remove the screw connection
(C)
,
• move the perforated plate holder
(D)
by
turning it 180 ° on the outside of the frame
tubes,
• insert the screw connection
(C)
again and
tighten the screws
(C)
tightly,
• reinsert the perforated plate with the screw
connection
(A)
and tighten the screws
(A)
.
The setting may not be possible if you want to
widen the seat, otherwise you will have to unscrew
the quick-release axle fittings too far out of the
perforated plate.
3.1.6 Camber
(3)
(B)
(C)
(A)
(D)
(2)
(A)
(B)
(E)
(C)
