8 von 36
Service record Dynamis MV
Service record Dynamis MV
2021-01-12
3.1 Wheels assembly
3.1.1 Center of gravity (wheelbase / perforated plate)
3.1.2 Adjustment of the seat height by changing the position of the caster wheel
(1)
(A)
(B)
(1)
To adjust the center of gravity
• remove both drive wheels,
• remove all screws
(A)
and nuts
• move the perforated plate into the al-
ternative holes
(B)
.
• Moving must be done in parallel on
both sides.
• Reinstall screws and nuts and tighten
tightly.
The parking brakes must be readjusted
after every change to the drive wheels.
Go carefully to the maximum and the
user (!) Desired point of tilt.
The further back you move the caster wheels, the greater the risk of the wheelchair tip-
ping forward when getting in and out.
The further you mount the drive wheels with the perforated plate to the front, the greater the
risk of the wheelchair tipping backwards.
When tilting the seat, please make sure that the gripping point and gripping path are not im-
paired by setting the drive wheels too high.
The drive wheel mount can be adjusted horizontally by up to 60 mm from the most passive po-
sition (0 mm).
(2)
(A)
(B)
(2)
The front seat height is adjusted via the po-
sition of the caster wheel in the caster fork.
• Completely remove the caster wheel /
caster fork screw connection
(A)
,
• Fasten the caster wheels in the desired
hole
(B)
on both sides,
• tighten all screws again.
After every change you have to check the
vertical tilt of the caster head and correct it if
necessary (see chapter caster head tilt).
Hair, lint, dirt, etc. collect on the bea-
rings of the caster wheels, making the cas-
ter wheels stiff. Remove the caster wheels
at short intervals and thoroughly clean the
forks, axles and sleeves.
Please proceed in the same way with plastic
forks.
