22 von 36
Service record Dynamis MV
Service record Dynamis MV
2021-01-12
3.7
Anti tipper assembly
3.7.1 Height adjustment
• (1)
Remove the screw
(A)
,
• pull the anti-tipper bar
(C)
in the holder
(A)
down a little,
• move the screw
(A)
to the desired posi-
tion
(B)
• and close it again.
Alternatively, you can turn the holder by 180 °:
(2)
If you want to set the anti-tipper particu-
larly low, you can turn the anti-tipper holder
(A)
by 180 °. To do this, remove the two screws
(E)
and the screw
(F)
, remove the anti-tipper
bar
(D)
and turn it 180 °, screw the anti-tipper
bracket firmly back onto the frame tube, insert
the anti-tipper bar back into the bracket and
position it according to your requirements
using the screw
(F)
in the holes
(1B)
.
(A)
(B)
(C)
(1)
(D)
(C)
(E)
(F)
(A)
(B)
(2)
3.7.2 Length adjustment
(3)
If you have adjusted your wheelchair very
actively and the anti-tipper sticks out too far
back, you can shorten the anti-tipper bar.
• Remove the anti-tipper wheel with hol-
der
(C)
with the screw
(B)
,
• Use a suitable saw to shorten the anti-
tipper bar to the desired length
• and put the anti-tipper wheel with hol-
der back on.
• Put the screw
(B)
in the appropriate
hole
(A)
and tighten it again.
(C)
(A)
(B)
(3)
