SORG Dynamis MV, Сервисная книжка

Страница: 9 / 36

Service record Dynamis MV 9 von 36 2021-01-12
3.1 Wheels assembly
3.1.3 Rear seat height, seat inclination
(1)
(B)
(A)
As a rule, the seat height at the back is selected approx. 2-3 cm lower than the seat height at
the front in order to achieve a safe and comfortable sitting position with good distribution of
the seat pressure and to avoid "slipping forward". However, other settings can also be useful in
individual cases.
• (1) Remove the drive wheels and remo-
ve the quick release axle fitting (A) with
all washers,
• move the quick-release axle fitting in -
cluding all washers into the alternative
holes (B)
• and tighten all screws again. (Tightening
torque of nuts M18 fitting 40 Nm).
• Mount the side parts and put the drive
wheels back into the quick-release axle.
The fittings must protrude equally far out of the perforated plate on both sides. The fittings may
only be unscrewed so far that the lateral distance between the tires at the top and the side panel
is as small as possible, but at least 10 mm.
3.1.4 Caster head tilt
The caster head inclination must be readjusted
after every change to the drive wheel.
For adjusting the caster wheel adapter:
• (3) Loosen all screws (A) (B) on both
sides.
• Bring the adapters into an exactly ver-
tical position by turning the adjusting
washer (C) (using a flat-blade screwdri -
ver) (create an angle).
• Tighten all screws again; Screws (A)
with 9 Nm, screw (B) with 7 Nm
(2)
(B)
(C)
(A)
An incorrectly set caster head inclination can lead to caster wheel flutter and when cor -
nering (due to the wheel caster) to cumbersome "uphill and downhill driving".