19
Installing an Input Adaptor
Cha
p
te
r 2
P
repa
ra
ti
ons
2
Insert the adaptor facing the board as shown below.
3
Push the adaptor in until it is firmly fit into the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
Installation of the input adaptor for Dual-
link connection
Two BKM-243HS or BKM-244CC input adaptors or one
BKM-250TG input adaptor is required for each input
block A to D. When the BKM-243HS or BKM-244CC
adaptors are used, install them in option slots 1 and 2. The
input adaptors of different models cannot be used at the
sama time.
To connect the input cables
When the BKM-243HS or BKM-244CC input
adaptors are used
Input the Link A signal to option slot 1, and Link B signal
to option slot 2.
Connect the cables to the connectors with the same input
number on the input adaptors installed in option slots 1 and
2.
When the BKM-250TG input adaptor is used
Input the Link A signal to INPUT 1, and Link B signal to
INPUT 2.
Board
Example when Dual-link input cables are connected
INPUT 2
INPUT 1
INPUT 2
INPUT 1
A
B
C
A
D
Option slot 1
Link A
Option slot 2
Link B
INPUT 2
INPUT 1
Example when Dual-link input cables are connected