18
Installing an Input Adaptor
Chap
te
r 2
Pr
epa
ra
tio
n
s
–: Not available
a)
At least four input adaptors are required. Use the same model of the input
adaptor.
b)
When the BKM-243HS or BKM-244CC input adaptor is used, prepare
eight and when the BKM-250TG is used, prepare four. Use the same
model of the input adaptor.
c)
When no sync signals are input to four inputs, the display screen becomes
no sync.
d)
One input adaptor is required for each input block.
e)
Two input adaptors are required for each input block when the BKM-
243HS or BKM-244CC is used and one input adaptor is required when the
BKM-250TG is used. Use the same model of the input adaptor.
Combination of the connection when an
SDI signal is input
To display the picture of an SDI signal, you can select
various combinations of the model or number of input
adaptors or Single-link or Dual-link connection. You may
not be able to configure the required combination of the
connection. Select the proper combination according to the
system in use.
For details on combination patterns, see “Connection
Combination Table When an SDI Signal Is Input” on page
112.
Installing an Input
Adaptor
Installing an Input Adaptor
Each input adaptor can be installed in any input option slot
on the side panel.
When you install the following input adaptor to this
equipment, use that with the serial numbers given below.
BKM-243HS with serial number 2108355 or higher
BKM-243HS: This equipment may not meet the
requirements of the electromagnetic interference standard
or work correctly, or you may not be satisfied with the
performance if designated input adaptors are not installed.
Turn off the MAIN POWER switch of the monitor and
disconnect the AC power cord before installing or
removing adaptors.
1
Loosen two screws and remove the cover of an input
option slot on the side panel of the monitor.
HDMI
a
c)
a
–
Input
signal
4K/QFHD
Quad View
2K/HD Zoom
Caution
Note
Cover of an
input option slot
Make sure the MAIN
POWER switch is turned
off, and disconnect the
AC power cord.
