Page 4
12’ Garden Master (3.5mm)
uu
Very Important!! NEVER glue
the underside of the Snap-T. You
need to be able to slide the Snap-T
along the pipe. You only glue tubes
into the enclosed arm
F.
uu
NOTE: Attaching Snap-T’s
this way prevents pinched
fingers! Use a small pipe and
step on the Snap-T.
B.
uu
Note: The 3-Way Metal Corner posts have a red mark
on the “dead end” arm. In order for all measurements to
be correct, the 3-Way Metal Corner Posts must be oriented
correctly on the Base Frame and on the End Wall Frames.
Follow lthe directions carefully about where the red arm is
pointing. Please look at these fittings and check out the
arm with the red marking.
D.
uu
Note: Tubes that are double-slotted
have slots on each end. Single-slotted
tubes only have slots on 1 end.
All Slotted ends attach to Snap-T’s.
C.
uu
PVC Pipe is White and flexable.
Composite Pipe is white with small gray
fibers throughout and will not bend.
E.
3-Way Corner Post
Post With
Red Marking
Center
of tube
“In” side of tube
uu
Note: All measurements are taken from the “in”
side of one tube to the center of the other tube
so one person can easily take the measurement by
her/himself.
A.
1. SIDE WALLS
Pieces Required:
6
75” Composite Tubing - ORANGE
8
75” Composite Tubing - ORANGE
(Single-Slotted)
30
Snap-T’s
1. Attach 1
Snap-T
about 23” from the end of the
75” tube
and a second Snap-T about 48 ¼” from the end of the
tube. (Do this to all 14 tubes -
Both slotted and non slotted tubes)
2. On two of the
non-slotted
side wall tubes add a snap-T
between the two snap-T’s. You can adjust the snap-T’s in a later step.
Side Walls are used in step 7.
75” Composite Tubing - Orange
Make 14
22 ¾”
48 ¼”
Snap-T
Very Important!! NEVER
glue the
underside of the Snap-T. You need to be
able to slide the Snap-T along the tube.
Slotted End
Step #2 is no longer
needed so it has been
deleted
Hints for Preassembly
