12’ Garden Master (3.5mm) Page 13
Attach
1” Screws
8B. BENCH ASSEMBLY
Pieces Required:
20
28” Composite Tubing - GREEN
(Double-Slotted)
42
1” Screws
92” Composite Tubing - Red
(Bench Rod)
28” Composite Tubing -Green
(
Double-Slotted
)
BB - 92” Composite Tubing - Red
(Bench Rod)
Attach screw here
(See picture below)
4-way Metal-T
22 ¾”
48 ¼”
28” Composite Tubing -Green (
Double-Slotted
)
Snap-T
1” screw
Top of Snap-T
Composite Tube
1. Insert
eight 28” Composite Tubes - Green (Double-Slotted)
into the 4-way Metal-T’s that are on the end walls. Attach
the opposite ends of the 28” Composite Tubes - Green (Double-Slotted) into the snap-T’s on the corner side wall tubes.
(
NOTE: The glue does not adhere to the Composite Tubing
. A
pply glue around the outer end of the pipe and inside
the top of the Snap-T fitting for lubrication. The tubing will be easier to slide into the Snap-T’s.)
You will need to
secure the tubing by putting a
1” Screw
through the top of the Snap-T and into the 28” Composite Tubes - Green
(Double-Slotted) - See picture below. Attach the remaining 28” Green Composite Tubes between the Snap-T’s on the rib
pipes and the Snap-T’s on the 92” Bench Rods using glue to lubricate and 1” Screws to secure.
2. Double check measurements and make sure that the 4 -way Metal-T’s on the End walls are at 22 ¾” and 48 ¼” from the
top of the BS - 92” Base Frame Tube to the center of the fitting. (See diagram above)
3. Adjust Bench Frame tubes (by moving Snap-T’s on the Ribs up or down) so Snap-T’s of each bottom bench frame
are at an equal height and level with each other. HINT: Use a rubber mallet to tap the snap-T up or down.
4. After everything is level
on the bench frames
, attach a
1” Screw
through the top of the vertical Snap-T’s on the Side Wall
Tubes to prevent shelf brackets from sliding down (See picture below).
