12’ Garden Master (3.5mm) Page 21
1. Loosen
turnbuckles
so the bolts of the
turnbuckle are out about 1” on each side.
2. Screw one 15”
steel anchor
into the ground
using a screwdriver, rod, or pipe. The eyelet should
be just showing above ground. This will prevent the
greenhouse from shifting. Also, make sure the
anchor is as close to the greenhouse as possible
for the most secure pull. Place 1 anchor at each of
the remaining corners of the greenhouse.
3. Slide the hook of one turnbuckle onto the eyelet of a
ground anchor. Slide a
Metal hook
through the
eyelet of a turnbuckle.
4. Hold the flat part of the hook up tight against
a corner rib outside the greenhouse. Using a ¼”
drill bit, drill a hole through each of the holes in the
metal Hook,
clear through the Solexx and the rib
including the ½” PVC pipe inside the rib.
5. From outside the greenhouse push a
bolt
through each hole in the
metal hook
and through
the rib.
6. From inside the greenhouse, slide a
washer
over
each bolt and secure it with a
lock nut.
Tighten the
locknuts.
7. Repeat this process on each of the other corners.
8. Tighten the turnbuckles to remove any slack.
Turnbuckle
Metal Hook
Eyelet of a
Buried Steel
Anchor
Tie Down Kit Instructions for 6 Anchors
(HN-10 Purchased separately)
Parts Needed:
6 - 15” or 30”Steel Anchors
6 - Turnbuckles
6 - Metal Hooks
12 - 1 ½ x ¼” bolts
12 - ¼” locknuts
12 - Washers
(You need a ¼” drill bit to
predrill for the bolt)
1”
1”
Step 1.
Step 3.
Step 4.
Step 6.
Turnbuckle
Lock nuts
Washer
