Sokkia SRX1, Руководство оператора, Страница: 144 / 184

22. WARNING AND ERROR MESSAGES
136
The input password consists of less than 3 characters. Input a password at least 3 characters in
length.
Job data is not developed. Or job may have broken.
Program mode (SDR) JOB data lost or cannot be read in. Create JOB data again.
Motor error EXXX
A problem has occurred with the motor drive and operation stops.
Power the SRX OFF then ON to correct the problem.
If this error message appears frequently, contact your Sokkia agent.
Need base pt. obs
During REM measurement, the observation of the target was not completed normally.
Reset and sight the prism and perform measurement again.
Need 1st obs
During missing line measurement, the observation of the starting position was not completed
normally.
Sight the starting position accurately and press
[OBS] to perform the measurement again.
New password Diff.
During new password setting, the passwords input twice are different. Input
new password twice correctly.
No data
When searching for or reading in coordinate data or searching for code data, the search stopped
either because the item in question does not exist or the data volume is large.
No solution
The calculation of the instrument station coordinates during resection does not converge.
Access the results and if necessary, perform the observations again.
Not exist point
When reading in coordinate values during instrument station registration etc., there is no
coordinates data registered in the memory and in the selected JOB. Register coordinate data first.
Out of range
During gradient % display, the display range (less than ± 1000%) has been exceeded.
During REM measurement, either the vertical angle has exceeded horizontal ±89° or the
measured distance is greater than 9999.999m.
Install the instrument station far from the target.
The instrument station coordinates calculated during resection are too high.
Perform the observation again.
During area calculation, results exceeded the display range.
Reflectorless not supported !!
Automatic sighting cannot be performed with in reflectorless mode.
Use the prism to carry out automatic sighting.