C
OMMAND
L
INE
I
NTERFACE
3-52
ip address
Use this command to set the IP address for this device. Use the
no
form to
restore the default IP address.
Syntax
ip address
{
ip-address netmask
|
bootp
|
dhcp
}
no ip address
•
ip-address
- IP address
•
netmask
- Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific
subnets.
•
bootp
- Obtains IP address from BOOTP.
•
dhcp
- Obtains IP address from DHCP.
Default Setting
IP address: 0.0.0.0
Netmask: 255.0.0.0
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management
access over the network. You can manually configure a specific IP
address, or direct the device to obtain an address from a BOOTP or
DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. Anything outside this format will not be
accepted by the configuration program.
•
If you select the
bootp
or
dhcp
option, IP is enabled but will not
function until a BOOTP or DHCP reply has been received. Requests
will be broadcast periodically by this device in an effort to learn its IP
address. (BOOTP and DHCP values can include the IP address,
default gateway, and subnet mask.)
Содержание 7500A/VCP - annexe 1
