B
ASIC
C
ONFIGURATION
1-7
Setting an IP Address
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual
— You must input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic
— The switch sends IP configuration requests to BOOTP or
DHCP servers on the network.
Note:
Only one VLAN interface can be assigned an IP address (the
default is VLAN 1.) This defines the management VLAN, the only
VLAN through which you can gain management access to the
switch. If you assign an IP address to any other VLAN, the new IP
address overrides the original IP address and this becomes the new
management VLAN.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and management
stations that exist on another network segment. Valid IP addresses consist
of four decimal numbers, 0 to 255, separated by periods. Anything outside
this format will not be accepted by the CLI program.
Note:
The IP address for the switch is assigned via DHCP by default.
Содержание 7500A/VCP - annexe 1
