SKYLUX Climax 36178, Руководство по установке

Страница: 32 / 88

E_MH_Installation_instructions_Skylux_Climax 20/11/2020
32/88
Supports and side supports
Assembly
The number of supports and their position is determined in relation to the glazing and the load. Check the length
of the support with regard to the depth of the conservatory and the load (g snow and wind); see the
graphs on pages 77 - 80 or use the Climafast calculation application.
The total sheet width of polycarbonate or acrylic plastic sheets is used except for the left and/or right sheet which
may be cut to fit. The axis distance between the AX supports = sheet width + 22 mm. Take into account a lateral
clearance of 5 mm on each side. All useful information for the processing and installation of glazing plastics can be
found on pages 17 & 18.
The total width is divided into equal parts of max. 700 mm when using glass. The glazing quantity is determined as
follows: (B – 60 mm)/ 700 rounded off upwards. The width of the glazing is determined as follows:
((B – 60 mm) / glazing units) – 22 mm. Please follow the instruction of your supplier for the glass.
Mark out the positions of the supports on the hinge profiles (on the gutter and wall) and check the axis-on-axis
measurements.
Standard installation for plastic sheets
AX = PL + 22 MM
AX AX AX
B
Position the assembled side supports on hinges S1 or
S2. The supports at the wall and gutter side must be
anchored in hinge profile S1 or S2 using ZSG screws. Do
this on the marked line that can be seen on the bottom
side of hinge profile S. First drill using a Ø of 4 mm for
supports with steel reinforcement.
Slide sheet supports TP(G) as far up as possible
against the wall profile and fasten them using 2 ZSG
screws using a neoprene seal. Ensure that all gutter
side stop profiles area aligned.
TP
ZSC
S1
S1/S2
ZSG
TP(G)
ZSC
S1/S2