Simrad SH80 - REV C, Руководство по установке

Страница: 77 / 200

Cable layout and connections
61
851--164300 / C
2 Secure the plug on the rear side of the Sonar Processor Unit
with the bracket.
If the delivered cable connector does not fit, replace it with a
suitable connector.
C4 - Sonar Interface Control
This are the control signals between the Sonar Processor Unit and
the Sonar Interface Unit. The cable is pre-connected to the Sonar
Interface Unit, and is equipped with a 37-pin female Delta
connector in the Sonar Processor Unit end. The cable length is 1.2
m.
1 Connect the plug to the connector on the far right hand side
of the Sonar Processor Unit.
→
Cable details on page 157.
C5 - Sonar Interface Serial
This is the serial lines fed from the Sonar Interface Unit to the
Sonar Processor Unit. The cable is pre-connected to the Sonar
Interface Unit, and is equipped with a special multi-connector in
the Sonar Processor Unit end. The cable length is 1.2 m.
1 Connect the plug to the connector on the circuit board in slot
J5 on the rear side of the Sonar Processor Unit.
→
Cable details on page 157.
C6 - Ethernet communication
This is the Ethernet signals between the Sonar Processor Unit and
the Sonar Interface Unit. The cable is included in the delivery, and
it is terminated with RJ-45 connectors on each end.
1 Connect the Ethernet cable to the RJ-45 connector on the
circuit board in slot
J4 on the Sonar Processor Unit.
2 Connect the Ethernet cable to the RJ-45 connector J6 in the
Sonar Interface Unit.
→
Cable details on page 158.
C7
-
Operating panel (USB)
This is a standard USB data cable. It connects between the
Operating Panel and the Processor Unit. The cable is included in
the standard delivery, and the cable length is 4,5 meters. The cable
has a quadratic USB connector in the Operating Panel end, and
rectangular USB connector in the Processor Unit end.
→
Figure 21 shows the connection to the Operating Panel.
→
The figure on page 59 shows the connection to the Sonar
Processing Unit.