Simrad SH80 - REV C, Руководство по установке

Страница: 148 / 200

Simrad SH80
132
851--164300 / C
10.9 Radio buoy system
Observe the following procedure to test the radio buoy system
interface.
1 Access the I/O Setup menu.
→
A procedure for this is located on page 121.
2 Select Sensors in the I/O Setup menu, then BuoySystem ,
and finally Buoy NMEA .
3 Observe the Sensor Config submenu appears at the bottom
of the menu field.
4 Check that the settings in the Sensor Config submenu
correspond to your requirements for the serial line.
5 Press Close to exit the Sensor Config menu.
6 Select the Objects menu, and check that the Buoy readout
( F ) is shown.
7 Select one of the buoys in the Objects menu, and verify that
the buoy data is shown in the dialogue below the menu.