Simrad SH80
16
851--164300 / C
Inspection and unpacking
Inspection
An inspection must be carried out immediately after the unit(s)
have arrived at their destination.
•
Check all wooden or cardboard boxes, plastic bags and pallets
for physical damage. Look for signs of dropping, immersion in
water or other mishandling.
•
If damage is detected externally, you will have to open the
packaging to check the contents.
- Request a representative of the carrier to be present while the
carton is opened, so any transportation damage can be
identified.
•
If any units are damaged, prepare an inspection report stating
the condition of the unit and actions taken. Describe the damage
and collect photographic evidence if possible. Send the
inspection report to Simrad as soon as possible.
•
If the units are not damaged, check the humidity absorbing
material. If required, dry or replace the bags, then repack the
unit(s) according to the packing instructions.
General unpacking procedure
Normal precautions for the handling, transportation and storage of
fragile electronic equipment must be undertaken.
Note
If the unit is not to be prepared for immediate use, you may consider
storing it unopened in its original packing material. However, it
may be useful to open the case to check its contents for damage and
retrieve any accompanying documentation.
•
Check the carton before opening it to ensure it shows no signs
of dropping, immersion in water or other mishandling.
- If the carton shows signs of such damage, refer to the
paragraph covering Inspection on receipt.
•
Place the carton on a stable work bench or on the floor with the
top of the carton uppermost.
•
In the absence of other instructions, always open the top of the
carton first. The contents will normally have been lowered into
the carton from above, so this will usually be the easiest route
to follow.
- Care must be used when opening the carton to ensure the
contents are not damaged.
Caution
Do not use a knife to open cardboard cartons - the contents may
lie close to the surface, and may be damaged by the blade.
Содержание SH80 - REV C
