Simrad ES60 - DATASHEET REV A, Руководство по установке

Страница: 90 / 162

Simrad ES60
2
On the ES60 computer, connect the receive signal
Rx
on
pin 2, the transmit signal
Tx
on pin 3, and
ground
on pin 5.
3
On the ITI transceiver, use connector
Serial A
. Connect the
receive signal
Rx
on pin 2, the transmit signal
Tx
on pin 3,
and
ground
on pin 5.
4
Ensure that the length of the cable does not exceed
approximately 50 meters. If a longer cable is required, you
may need to use buffer ampli fi ers on the serial line.
Setup procedure
1
On the ES60, access the
Install
menu, and open the
Trawl
Interface
dialogue box.
2
Click the
RS232
button to open the
RS232 Setup
dialogue.
3
Enter the identi fi cation of the RS-232 port you have used
to make the connection.
4
Enter the correct communication parameters, and click
OK
.
5
Ensure that the transmit parameters on the ITI matches the
receive parameters on the ES60.
6
Click the
Depth output
button to open the
Depth Output
dialogue.
7
Click
Depth output
to enable the communication.
8
For
Telegram
, select
$SDDBS
.
9
Click
Ok
to exit the
Depth Output
dialogue.
10
Click
Ok
to exit the
Trawl Interface
dialogue.
Related topics
Generic RS-232 Serial line cable
on page 47
Cable between ITI and echo sounder
on page 64
Catch monitoring system interface
Communication with the Simrad PI Family catch monitoring
systems is based on NMEA telegrams. This is a two-way serial
communication line, and the following information is normally
exchanged:
• From ES60 to PI: Sounder depth below surface ($SDDBS
telegram)
• From PI to ES60: Data output (PSIMP,D)
The PI system can export other information as well, but only the
mentioned data can be processed and used by the echo sounder.
Wiring procedure
1
Locate a free RS-232 serial port that can be used to connect
the PI system.
88
304699/A