Simrad ES60 - DATASHEET REV A, Руководство по установке

Страница: 91 / 162

Interfaces and integration
2
On the ES60 computer, connect the receive signal
Rx
on
pin 2, the transmit signal
Tx
on pin 3, and
ground
on pin 5.
3
On PI44 and PI54, use either connector
NMEA1
or
NMEA2
.
Connect the receive signal
Rx
on pin 8, the transmit signal
Tx
on pin 6, and
ground
on pins 7 and 9.
4
On PI30 and PI32, use connector
NMEA
. Connect the
receive signal
Rx
on pin 3, the transmit signal
Tx
on pin 1,
and
ground
on pins 2 and 4.
5
Ensure that the length of the cable does not exceed
approximately 50 meters. If a longer cable is required, you
may need to use buffer ampli fi ers on the serial line.
Setup procedure
1
On the ES60, access the
Install
menu, and open the
Purse
Interface
dialogue box.
2
Click the
RS232
button to open the
RS232 Setup
dialogue.
3
Enter the identi fi cation of the RS-232 port you have used
to make the connection.
4
Enter the correct communication parameters, and click
OK
.
5
Ensure that the transmit parameters on the PI system
matches the receive parameters on the ES60.
6
Click the
Depth output
button to open the
Depth Output
dialogue.
7
Click
Depth output
to enable the communication.
8
For
Telegram
, select
$SDDBS
.
9
Click
Ok
to exit the
Depth Output
dialogue.
10
Click
Ok
to exit the
Purse Interface
dialogue.
Related topics
Generic RS-232 Serial line cable
on page 47
Cable between PI44/54 and echo sounder
on page 65
Cable between PI30/32 and echo sounder
on page 66
Input interfaces
The following interfaces are set up to receive information from
external devices.
• Navigation system
• Heave sensor
• Temperature sensor
304699/A
89