Installation Instructions Document No. 466-1574
.
30
phone test (3 digits must be entered).
To set system option 17:
1. Press Add from the Start menu.
2. Press Option # 17.
3. Enter the dialer delay in seconds (3 digits must
be entered).
To set system option 18:
1. Press Add from the Start menu.
2. Press Option # 18.
3. Enter the alarm cancel time in minutes (2 dig-
its must be entered).
To set system option 19:
1. Press Add from the Start menu.
2. Press Option # 19.
3. Enter the supervisory time in hours (2 digits
must be entered).
To set system options 20 - 26, 28 - 30, and 32:
1. Press Add from the Start menu.
2. Press Option # XX.
3. Press DONE.
To set system option 27:
1. Press Add from the Start menu.
2. Press Option # 27.
3. Enter the ring/hang/ring number.
To set system option 31:
1. Press Add from the Start menu.
2. Press Option # 31.
3. Enter the day of week number.
To set system option 33, 38, 40-42:
1. Press Add from the Start menu.
2. Press Option # XX.
3. Press DONE.
To set system options 34-37:
1. Press Add from the Start menu.
2. Press Option # XX.
3. Press Hours and Minutes to set the time.
4. Press DONE.
To set system option 39:
1. Press Add from the Start menu.
2. Press Option # 39.
3. Enter the minutes (2 digits must be entered).
To set system option 43:
1. Press Add from the Start menu.
2. Press Option # 43.
3. Enter a phone number with the red numbered
keys. Press Test to enter a pause in the phone
number.
Note
: The phone number is automatically stored after
you’ve pressed 22 digits. You will not have to press DONE
to store the number. If the number is less than 22 digits,
then DONE must be pressed.
To set system option 44:
1. Press Add from the Start menu.
2. Press Option # 44.
3. Enter phone mod number.
To set system option 45 - 53:
1. Press Add from the Start menu.
2. Press Option # XX.
3. Press DONE.
To delete options:
1. Press Delete from the Start menu.
2. Press Option from the Main menu until you hear
the name you want to delete or use the red num-
bered keys to go directly to the option.
3. Press DONE. The system confirms the item you
deleted.
Programming System Access Codes
Use Table 7 on page 10, which was filled out during
the system planning, to program system Access
Codes.
To add a code:
1. Press the Add button.
2. Press the Access Code button. Continue pressing
the Access Code button until you hear the access
code to be changed.
3. Press DONE.
4. Enter the new access code by using the red
numbered keys.
The Control Panel says, code name is XXXX (the new
4 digit access code).
