Siemens SIMATIC HMI Industrial Thin Client ITC1200, Руководство по эксплуатации

Страница: 46 / 132

Assigning device parameters
5.3 Configuration settings of the device
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
46
Operating Instructions, 04/2013, A5E03474888-02
5.3.4 Network settings
Introduction
The following figure shows the network settings in the Start menu "Configuration > Network".
You can perform the following actions:
●
Specify network parameters
● Assign network parameters dynamically
● Use DNS server
● Check valid settings
● Specify speed and mode of the connection
Note
These network settings are not relevant for the SINUMERIK connection. The SINUMERIK
connection automatically obtains its network settings from the system network.
Note
During a SINUMERIK connection, a new IP address is assigned to the device with the
following effect:

Any active RDP connection is terminated.
 Remote maintenance of the device is no longer possible.
When the SINUMERIK connection is closed, the original IP address is restored.