Siemens SIMATIC HMI Industrial Thin Client ITC1200, Руководство по эксплуатации

Страница: 33 / 132

Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
33
Commissioning the device
4
4.1 Switching on and testing the device
Procedure
Proceed as follows:
1.
Switch on the power supply.
Information regarding the included free software is displayed during startup.
If the device fails to start, you may have crossed the wires on the mains terminal. Check
the connected wires and change their connection.
Additional information is available in the configuration settings, Section Basics (Page 50).
Make sure that you observe the warning at the end of the section.
Setup Wizard
The first time the device starts up, the Setup Wizard remains open until the configuration
settings become valid. The Setup Wizard guides you through the configuration of selected
device and network data as well as passwords and connection settings.
The Setup Wizard starts again when the factory settings are restored or the firmware is
updated.
Function test
Perform a function test following commissioning. The device is functional if one of the
following states occurs:
●
The taskbar is displayed.
● The configured startup connections are established.
Procedure - Switching off the device
Proceed as follows:
1.
Terminate all client-server connections and close all programs.
2. Switch off the power supply.
Restart
You restart the device, for example, in order to test the startup connections.
When the "Restart" menu command is hidden, select "Permit restart" (see section "Password
settings (Page 58)").
1.
Choose "Restart" from the task bar in the start menu. A confirmation prompt is displayed
first.
2. Click "Yes" to confirm. The device restarts.