Siemens SIMATIC HMI Industrial Thin Client ITC1200, Руководство по эксплуатации

Страница: 45 / 132

Assigning device parameters
5.3 Configuration settings of the device
Industrial Thin Client ITC1200, ITC1500, ITC1900, ITC2200
Operating Instructions, 04/2013, A5E03474888-02
45
Note
Faulty touch operation
The touch screen must be recalibrated.
Procedure:
1.
Touch the "Restore to factory settings" button. The "Resetting to factory defaults"
message is shown on the touch screen. The device reboots automatically if you confirm
this message.
2. You can also switch the power off and on again and press the "Factory Settings"
hardware button on the device with a pointed object for at least three seconds during the
restart. A message is briefly displayed. Then the device restarts automatically.
Perform remote maintenance on device
Allows remote access to the device. The device has a VNC server for this purpose. With
VNC remote access, you can "Permit access to Desktop" or "Permit operation", in other
works, enable operation of the plant or machine from the device. You also set the "Port" for
remote access.
Note
During a SINUMERIK connection, a new IP address is assigned to the device. Remote
maintenance of the device is then no longer possible.
For remote maintenance, use the IP address that was assigned by the SINUMERIK
connection.
Activate remote configuration
Remote configuration made possible by SSH is enabled by default. But SSH poses a
potential security risk. Detailed information is available in the section "Backing up remote
configuration (Page 77)". If you do not need remote configuration, deactivate "SSH".
See also
Opening the configuration (Page 35)
Network settings (Page 46)
Remote configuration of several devices (Page 66)
Layout of the devices (Page 11)
Switching on and testing the device (Page 33)
SIMATIC Thin Client (
)