Siemens HB373AB.0, Инструкция по эксплуатации

Страница: 18 / 40

NL racks
Before cleaning
Change and abort
The interior space must be empty. Remove the
accessories, molds and rails from the interior. In the
relevant chapter you can read how the racks are
removed. ~"
Racks" on page 18
The cleaning mode cannot be changed after the start.
The end time can be changed as long as the device is
on hold.
Clean the appliance door and the edge surfaces of the
interior at the door seal. Do not sand or wipe the seal!
If you want to cancel the cleaning function, switch the
appliance off by turning the function selector knob to the
zero position.
Clean the inner door glass with warm soapy water
and a cleaning cloth. Dry with a soft cloth. Use oven
spray for heavy soiling.
The appliance door may remain locked until the cooking
compartment has cooled down sufficiently and the lock
symbol has disappeared from the display.
:
Warning
Risk of fire!
After cleaning
■
Loose food residues, grease and meat juices can
catch fire during cleaning. Always remove coarse
contamination from the interior before cleaning
starts. Do not clean any accessories.
risk of fire!
The outside of the appliance gets very hot
during cleaning. Never hang flammable objects, such
as drying towels, on the door handle. Keep the front
of the device free. Make sure there are no children
around.
risk of fire!
High heat escapes when the door seal is damaged
within reach of the door. Do not sand or wipe the
seal. Never use the appliance with
use damaged seal or without seal;
Let the interior cool down thoroughly. Wipe the
remaining ash in the interior and at the
appliance door with a damp cloth.
R
■
Put the racks back in.
Note: As a result of excessive contamination, a white
deposit can form on the enamel surfaces. These are
leftovers of foodstuffs that are harmless. They do not
affect operation. You can remove the food residues with
citric acid if necessary.
R
■
Set cleaning function
p racks
Before setting the cleaning function, make sure that you
follow all the preparation instructions.
stretch you
When properly maintained and cleaned, your
appliance will continue to look good and function
properly for a long time to come. Here we explain how
to remove and clean the racks.
The time for each cleaning mode is fixed and cannot be
changed.
1.
Using the Self-cleaning function selector
V
Set up.
2.
Set the cleaning level with the temperature selector.
The display shows a time duration for each setting. The
cleaning function starts after a few seconds. The time
counts down on the display.
Remove and attach racks
:
Warning – Risk of burns!
The racks get very hot. Never touch the hot racks.
Always allow the appliance to cool down. Make
sure there are no children around.
Make sure the kitchen is ventilated while the cleaning
is running.
Remove racks
Shortly after starting, the appliance door locks. The
symbol appears in the display
h.
When cleaning is finished, a signal sounds. The display
shows the duration at zero. Switch off the appliance by
turning the function selector knob to the zero position.
The appliance door cannot be opened again until the
cooking compartment has cooled down sufficiently and
the lock symbol
huh
has disappeared.
Set the end time to a later time
You can postpone the end time. Press key before start v
until the end symbol is highlighted in the display. Use
the @ button to postpone the end.
After starting, the device goes into standby mode.
18