SICK NAV310, Руководство по эксплуатации

Страница: 32 / 55

Electrical installation
32
© SICK AG · Germany · All rights reserved · Subject to change without notice
8016535/1D2F/2022-11-14
Operating instructions
NAV310 Laser positioning sensor
Chapter 5
“Power” connection M12 × 5, plug, A coded
“Ethernet” connection M12 × 4, socket, D coded
“RS232” connection M12 × 8, plug, A coded
5.3 Preparing the electrical installation
5.3.1 Supply voltage
DC 24 V ±15 % as per IEC 60 364-4-41 (pay attention to permitted cable lengths in tab. 11
on page 33 )
The NAV310 draws the following power:
• on switching on without switching outputs wired maximum 36 W
• in operation typically 12 W, plus a maximum of 12 W with switching output wired
The supply of power/the external power supply for the supply of power must be able to
provide at least 40 W continuous power, if the switching output is wired at least 48 W
continuous power.
Pin Signal Function
1 V
S
Supply voltage NAV310
2 V
S
Supply voltage NAV310
3 GND Ground
4 OUT 24 V Digital output 1
5 GND Ground
Tab. 8: Pin assignment of the “Power” connection on the NAV310
4
2
3
5
1
Pin Signal Function
1 Ethe Ethernet interface
2 Ethe Ethernet interface
3 Ethernet_TX– Ethernet interface
4 Ethernet_RX– Ethernet interface
Tab. 9: Pin assignment of the “Ethernet” connection on the NAV310
1
2
4
3
Pin Signal Function
1 RxD Serial RS232 host interface (receiver)
2 TxD Serial RS232 host interface (sender)
3 – Do not use
4 – Do not use
5 GND RS-232 Ground RS-232
6 OUT 24 V Do not use
7 OUT 24 V Do not use
8 OUT 24 V Do not use
Tab. 10: Pin assignment of the “RS232” connection on the NAV310
2
1
8
7
6 5
4
3