7
OPERATION
8020065-ZSP4/2017-08-10|SICK
O P E R A T I N G I N S T R U C T I O N S | Master Data Analyzer
Subject to change without notice
86
7.5
Performing new measurements
You can start the next measurement as soon as you have removed the object.
•
As the operating mode without bar code scanning does not support the temporary
memory bank, you must make sure that the measurement results have been
transmitted before starting the next measurement.
•
In the operating mode with bar code scanning, the data also can be stored temporary
if you wish to continue with the next measurement. The data can also be transmitted at
a later point once the device has been reconnected to the server.
Moving the measurement gantry to the end position
1. Move the measurement gantry to a position that enables you to remove the object
easily without obstruction (e.g., to the end position).
Do not move the measurement gantry back over the object otherwise the system will
start a new measurement.
2. Remove the object from the glass panel.
Fig. 48: Moving the measurement gantry to the end position
NOTE
Ensuring a smooth conclusion of the measurement process
▸
Provided that the measurement gantry is not located over the object, remove the
object. The measurement is not yet complete.
▸
There is a risk that the light grids may be damaged when removing the object.
Note
Note
