5
ELECTRICAL INSTALLATION
8020065-ZSP4/2017-08-10|SICK
O P E R A T I N G I N S T R U C T I O N S | Master Data Analyzer
Subject to change without notice
48
5.3
Connecting the MDA to the target network
Data is transmitted to the target network using the
Data
Ethernet interface as standard.
The Ethernet cable is not included with the delivery.
Creating connections
Fig. 33: Connecting the MDA to the Ethernet
1. Plug the Ethernet cable’s RJ45 male connector into the
Data
female connector on the
MDA.
2. Route the cable to a free Ethernet female connector for the target network.
3. Establish the Ethernet connection to the target network.
5.4
Connecting the sliding table with rechargeable battery
If you would like to operate the Master Data Analyzer on the sliding table with an integrated
rechargeable battery, the MDA should be connected to the battery rather than the mains
voltage supply.
An unconnected cable end has been fed out of the rechargeable battery for the connection.
The cable end has an M12 plug connector.
1. Connect the M12 female connector for the cable feeding out of the rechargeable
battery to the
24 V DC
male connector on the MDA.
2. Screw in the plug connector.
3. Make sure the connection is secure.
