MAIN POWER SWITCH (RED) (con’t)
1. Remove the six screws holding the Frame
Cover. Set screws and Frame Cover aside
(Figure 3-55).
2. Remove the seven screws holding the Mandrel
Support Plate, set screws and plate aside.
3. Remove the three spade connectors from the
back of the Main Power Switch (Figure 3-56).
4. The switch is held in place by four retaining
clips, squeeze clips on either side of the switch
while firmly pushing switch out of Rear Face
Plate (Figure 3-57).
5. Orientate switch so the plastic divider is on the
left side as you are looking at the back of the
switch as you snap it into the Rear Face Plate.
Snap replacement switch into Rear Face Plate.
6. Reconnect the three spade connectors. The
Light Blue wire is attached to the contact
furthest from you; the two Black wires are
attached to the remaining contacts.
REPLACEMENT
Figure 3-55. Frame Cover Screws
Figure 3-56. Plastic divider location
Plastic divider
Figure 3-57. Back of Main Power Switch
Retaining
Clips
Always remove electrical power from the
SX
prior to performing any maintenance
on the machine.
WARNING
SX
™
Service and Maintenance Manual 3-21 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
ELECTRICAL COMPONENTS
