Sharp AR-650, Руководство по обслуживанию

Страница: 26 / 200

1 - 19 ADJUSTMENT
05 MODE
CODE ADJUSMENT MODE DEFAULT RANGE DESCRIPTION
PROCEDURE
GROUP
#461 PFP lower paper alignment (paper buckle) All 7 0-15 1
at the PFP lower registration roller.
#462 Duplexer registration roller paper alignment All 4 0-15 1
(paper buckle)
464 Duplexer end guide shifting amount All 2 0-3 1
# Key in the value, press the SET key to store or the CLEAR key to reset.
▲
468-0 Binding position/folding position fine adjustment All 0 -14-14 6
(A4-R/LT-R)
▲
468-1 Binding position/folding position fine All 0 -14-14
adjustment (B4).
▲
468-2 Binding position/folding position fine adjustment All 0 -14-14
(A3/LD)
469 Finisher aligning speed adjustment All 0 0-4 1
▲
Key in Code 468 press the Start key, key in the Sub Code, then press the START key. Key in the value, press SET key to
store or the CLEAR key to reset.
470 Paper remaining indicator. Automatic All — 0-31 8
adjustment for EMPTY condition. LCF and
Drawers.
Increasing the value by 1
increases the aligning (paper
buckle) by 0.9mm.
Increasing the value by 1
increases the aligning (paper
buckle) by 0.9mm.
In stacking of only a few sheets
in the case of the following
values only, the end guide is
moved towards the pickup
roller compared with the
standard pickup roller position.
If the paper is a large size than
the standard one or it has
much curing or the edges are
turned, then if a jam occurs,
the position of the end guide is
lowered. This will help to
decrease the possibility of
future jams.
0: A3/LD 0~2mm, other. 0~2mm
1: A3/LD 0~2mm, other. 0~0mm
2: A3/LD 0~4mm, other. 0~2mm
3: A3/LD 0~4mm, other. 0~0mm
Position shifts to the right page
0.25mm/step.
0: High
1: Middle-high
2: Middle
3: Middle-low
4: Low
If the adjustment value is made
larger, the finisher aligning
speed becomes slower.
If the paper exiting to the
finisher becomes misaligned or
there are staple jams, then
only on these occasions these
codes should be used.
Remove all of the paper from
the LCF and PFP, then
perform the automatic
adjustment.