Schmalz JumboPicker-Flex, Инструкция по эксплуатации и техническому обслуживанию

Страница: 47 / 71

30.30.01.01183/00 www.schmalz.com EN | 47
Problem Solution
Preventive measures
Supply hose is damaged
-
Install a new hose or cut out the
damaged section and connect the
remaining sections using pipe
nipples and hose clamps.
-
Remove objects or edges in the
way.
-
Correct hose path.
Lift tube is damaged -
Install a new lift tube
-
Do not move to the end stop

Set the hovering position (see
section 5.5)
-
Do not use tube lifter to lift at
an angle (see section 6.3)
-
Shorten maintenance interval
for filter in operator handle (see
section 9.8)
Suction cup connection has a
leak -
Check the sealing rubber at the
hose connection and replace if
necessary
The hose on the suction cup is
damaged (double- and four-
head suction gripper)
-
Check hose, replace if
necessary
-
Remove objects or edges in
the way
The load falls when lowering -
Consult with the manufacturer
-
Consult with the manufacturer
Vacuum is attained but the tube
lifter cannot lift porous loads -
Consult with the manufacturer
-
Consult with the manufacturer
While the tube lifter is in use,
the operator handle of the tube
lifter remains in the upper end
stop position without load and
cannot be lowered or can only
be lowered slowly by pressing
the button.
-
Check the adjustment wheel for
the hovering position without
load (rotate right to lower the
hovering position)
-
Set the hovering position (see
section 5.5).
-
Shorten maintenance interval
for filter in operator handle (see
section 9.4).
Load cannot be released from
the gripper
-
Clean or replace the dust filter
cartridge to permit reliable
venting
-
Shorten maintenance interval
for filter (see section 9.8)
Safety switch does not lock into
place.
-
Secure attachment of the
components
-
Deposits or wear
-
Leak tightness of cable inlet
-
Loose line/plug connections.
-
Shorten maintenance interval
Safety switch will not release
from locked position -
Push scissor arm / lift tube
toward the safety switch
Error message on control panel
-
Restart system.
-
Error occurs again. Consult
with the manufacturer