Schmalz JumboPicker-Flex, Инструкция по эксплуатации и техническому обслуживанию

Страница: 52 / 71

52 | EN www.schmalz.com 30.30.01.01183/00
Interval
Daily Weekly Monthly Every
six
months
Annual
check
Scissor arm and connection
Check all load-bearing parts (e.g. bearings in the
scissor arm segments) for: correct attachment,
deformation, wear or other damage
X
Check the mechanical connection to the industrial
truck.
X
Check the safety switch for deformation, wear or
other damage and to ensure it is functioning
properly.
X X
Check that the scissor arm moves smoothly. X
Type plate and maximum load plate attached and
legible.
X
Check the tightening torques for screw connections
that affect safety
X
Function
Can the device be easily raised and lowered when
not carrying a vacuum-gripped load?
X X
Does the non-return valve work when there is a
power failure?
X X X
Is the UVV (German Accident Prevention
Regulations) test label current?
X
General condition of the device X
9.5 Cleaning
Use cleaning solvents to clean the system (not petroleum ether or corrosive liquids; the use of
petroleum ether or corrosive liquids could cause leaks in the supply hose or lift tube). The suction
plates can be cleaned using soap and warm water. Do not use cleaning solvents on the suction
sealing lips.
9.6 Removing the Covers

Remove two screws on bottom

Loosen four locknuts on side

Pull the hood backward out of the holding brackets.

Remove two screws on bottom

Remove the two hexagonal nuts and washers

Remove the cable bushing and cables from the hole
in the hood

Lift up to remove the hood.