Sanyo SPW-CR365GX56, Технические данные инструкция

Страница: 79 / 345

3
3 - 33
Control of Mini ECO-i SYSTEM
3. Wired Remote Controller
I
Basic Wiring Diagram
CAUTION
Install wiring correctly
(incorrect wiring will dam-
age the equipment).
G Use shielded wires for remote control wiring and
ground the shield on both sides. Otherwise misop-
eration due to electrical noise may occur.
Shielded wire
Ground
1 2
1
1 2
1 2
1
1 2
1
1 2
1
: Ground
Outdoor unit
Indoor unit
No. 8
Indoor unit
No. 3
Indoor unit
No. 2
Indoor unit
No. 1
1
Group
control
Connection wiring
for group control
Standard
remote control Multiple
remote control
1 1
1
Inter-unit control wiring
Terminal
3P
2 2
2
2
2 2 2
2
Remote
control wiring
Inter-unit wiring
Group-control wiring
(Main) (Sub)
Indoor
unit 8 Indoor
unit 7 Indoor
unit 2 Indoor
unit 1
I
Wiring System Diagram for Group Control
This diagram shows when several units (maximum of
8) are controlled by a remote controller (main unit). In
this case, a remote controller can be connected at
any indoor unit.
Wiring procedure
Wire according to the diagram at right:
G
Each successive unit will respond at 1-second
intervals following the order of the group address
when the remote controller is operated.
Group control using 2 remote controllers
It does not matter which of the 2 remote controllers
you set as the main controller.
When using multiple remote controllers (up to 2 can
be used), one serves as the main remote controller
and the other as the sub-remote controller.
1 2
1
1 2
1 2
1
1 2
1
1 2
1
Outdoor unit
Indoor unit
No. 8
Indoor unit
No. 3
Indoor unit
No. 2
Indoor unit
No. 1
1
Remote
controller
Connection wiring for
group control
Inter-unit
control
wiring
Terminal
3P
2
2
2 2
2
(sub)
3P terminal
base for remote
control wiring
Remote
controller
(main)
1
Indoor unit
No. 1
: Ground (earth)
Indoor unit
No. 2
Indoor unit
No. 8
Indoor unit
No. 3
Connection wiring
for group control
1 1
1 2
2 2 2 1
2 1
2
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 33