Sanyo SGP-E120J2GU2, Руководство пользователя

Страница: 92 / 175

Construction
E - 5
1. Points regarding refrigerant piping construction
(3) Refrigerant piping connection operations
1
Refrigerant piping materials
Piping should be “phosphorous de-oxidized copper seamless tube (C1220T).” Piping size shall be in accordance
with the following table.
●
All the unit piping, including the branch must be insulated. The gas side system (thick pipe) must be
insulated to greater than 120
o
C, and the liquid side (thin pipe) to greater than 80
o
C. (See Figure 1.)
For external diameters of 38.1mm or more the thickness should be
15mm, and for other sizes it should be 10mm.
If the conditions within the ceiling can exceed DB30
o
C or RH70%
then this thickness should be increased.
Improper insulationg can be the cause of water leaks and
condensation.
Use separate conduit for the electricity cables and the operation
cables. If the same conduit is used, a malfunction may result from
the effects of noise and induction.
Caution
Nominal external
diameter
φ
6.35
φ
9.52
φ
12.7
φ
15.88
φ
19.05
φ
22.2
φ
25.4
φ
28.58
φ
31.75
φ
38.1
φ
41.28
φ
44.45
φ
50.8
Thickness T0.8 T0.8 T0.8 T1.0 T1.0 T1.15 T1.0 T1.0 T1.1 T1.15 T1.2 T1.25 T1.4
Specification
Ｏ
material 1/2H or H material
2
Cautions regarding construction
Thermal insulation
(heat resistant to
greater than 120 )
Operation cable
Thermal insulation
Gas pipe side
(thick pipe) Liquid pipe side
(thin pipe)
Ornamental tape
(to prevent rain
and water access)
3
Select the gas pipe (thick pipe), liquid pipe (thin pipe), branches (separately sold) and make necessary
preparations for installation.
●
After cutting the pipe, remove all burrs, and correctly finish the ends.
(similarly for separately sold branch fittings)
●
During cutting and bending operations do not damage the pipe.
●
Make sure that no water or sand can enter the pipe.
4
Connecting pipes
●
Carry out as follows.
1) Remove the fixing rubber by removing the gas pipe and the liquid pipe fixing
panel from the piping connection panel (See Fig. 3.).
2) Connect the piping, and braze.
3) Return the fixing rubber to the gas pipe and the liquid pipe. (Fig. 4)
Caution
Before brazing operations, complete the following.
●
The rubber for fixing the pipe is not resistant to heat, so before brazing be sure to remove it.
●
During brazing, cool the piping with wet cloth, etc. so that the heat does not cause damage to the valve
inside of the equipment.
●
Commercial anti-oxidants have adverse reactions on refrigerants and the refrigeration oil, so they should not
be used
Piping
connection
panel
Liquid pipe
fixing panel
Gas pipe
fixing rubber
Gas pipe
fixing panel
Liquid pipe
fixing rubber
Liquid pipe
(thin pipe)
Gas pipe
(thick pipe)
Brazing
Fig. 1
Fig. 2
Fig. 3 Fig. 4