Sanyo 85402843, Руководство по обслуживанию

Страница: 19 / 252

2 - 5
Mini ECO-i System
Remote Controller Functions
2
3. Detailed Settings Function
All settings except for the system address, indoor unit
address, and group address were set at the time of
shipment. The following procedures are necessary
only when the functions are changed.
The functions cannot be changed in the case of a
wireless remote controller or a system with no remote
controller.
Change the functions using the wired remote con-
troller (RCS-TM80BG).
<Function>
Sets items which are highly important for system
operation, such as the system address, indoor unit
address, and group address, at the individual or
group-control indoor unit(s) where the remote con-
troller that is used for making detailed settings is con-
nected.
These settings are for items that are extremely
important for system operation. Serious trouble
may occur if they are set incorrectly. Please use
sufficient caution when changing the settings.
Some item codes which do not appear in the list
are also displayed. These item codes were set at
the time of shipment from the factory to the opti-
mal settings for that model; do not change them.
Do not change any settings data which does not
appear in this list.
<Procedure>
(Perform these steps with the unit stopped.)
Press and hold the (TEST/CHK) button, the
(SET) button and (CANCEL) button
simultaneously for 4 seconds or longer. Check
that the (SETTING) display on the
remote controller begins to blink.
If group control is in effect, press the
(UNIT SELECT) button and select the address
(unit No.) of the indoor unit to set. At this time, the
indoor unit fan begins operating.
Press the temperature setting /
buttons to select the item code to change.
3
2
1
CAUTION
2
3
7
1 5
4
Fig. 2
Press the timer time / buttons to select
the desired setting data.
* For item codes and setting data, refer to the
following page.
Press the (SET) button. The (SET-
TING) display stops blinking and remains lit, and
setting is completed. (If the (SET) button is not
pressed, the settings data will not be changed.)
Repeat steps (2) – (5) and change the settings.
<Restoring normal mode>
Press the (TEST/CHK) button. Check that the
remote controller display disappears.
7
6
5
4
06-408 Mini_ECOi_SM2 11/10/06 5:18 PM Page 5
获取更多资料
微信搜索蓝领星球