SY26U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 1119
4-49
T
ABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
•
Make sure the loading ramps have adequate width,
length, thickness, and strength. The maximum angle of
the ramps is 15° (1).
•
Never change direction on the access ramp. If
repositioning the machine is necessary, back up, re-
orient the machine, and drive up or down the ramps.
•
Use care when driving over the joints (2) between the
trailer and the ramps.
•
Swinging the upper structure may cause the machine to
tip over and result in personal injury. Retract and lower
the arm and swing the upper structure slowly to
achieve the optimal balance.
•
Never operate any control levers other than the travel
levers when the machine is on a ramp.
•
Clean the loading platform, ramps, and trailer floor
before loading or unloading. Grease, mud, or ice on the
trailer, loading platform, or ramps can cause the
machine to slide and tip over.
Loading the Machine
Use a loading platform or ramps when loading or
unloading the machine.
Fig. 4-66
0002935
1
Fig. 4-67
0002933
2
Fig. 4-68
0002931
