SY26U Excavator OMM
Machine Operation
SANY
Operation and Maintenance Manual — 1119
4-33
T
ABL
E OF
CONT
E
N
TS
INTRODUCTION
SAFE
T
Y
MACHIN
E
CONTROLS
MACHINE
OP
ERA
T
IO
N
MA
INTENANCE
SPEC
IFI
CA
TIO
N
S
OP
T
IO
N
A
L
EQUI
PMENT
•
Do not drive or swing the machine on broken stones,
rugged surfaces, steel bars, or scrap iron. This could
cause personal injury or track damage.
•
Do not perform operations where the rubber tracks
may skid. This can cause early track wear.
•
Slow the machine when traveling on uneven ground. A
lower speed reduces the possibility of machine
damage.
•
Do not operate the machine on a surface covered by
small stones that could cause track skidding or damage.
•
Avoid premature track wear or damage. Do not operate
the machine on new asphalt or other hot surfaces.
•
Do not allow fuels, oils, salt, or chemical solvents to
make contact with the tracks. These substances will
erode the track links and cause rusting and peeling.
Wash these substances off the tracks immediately with
clean water.
•
Avoid operation of the machine in a marine
environment. Salt in seawater can damage the tracks.
Rinse the tracks if they were exposed to salt or salt
water.
Traveling at High Speed
When traveling at high speeds, position the idlers to the front of the canopy.
Fig. 4-45
0002882
Fig. 4-46
0002884
