Santerno SINUS MV, Руководство пользователя

Страница: 64 / 115

59
Parameter name Description Value Unit
Default
value
Change
Baud rate
The setting of communication baud rate in Upper
communication
0 ： 1200
1 ： 2400
2 ： 4800
3 ： 9600
4 : 19200
5 : 38400
No 3 ○
Fan control Set the fan start/stop
0
：
Stop
1
：
Start
No 0 ○
Light fault energized
When the VFD has a light fault, whether or not
to allow the VFD energized on MV to continue to
work
0
：
Disable
1 : Enable
No 0 ○
Jump frequency 1L Lower limit of jump frequency 1, see 5.3.11 0.00~80.00 Hz 51.00 ○
Jump frequency 1U Upper limit of jump frequency 1,see 5.3.11 0.00~80.00 Hz 51.00 ○
Jump frequency 2L Lower limit of jump frequency 2, see 5.3.11 0.00~80.00 Hz 51.00 ○
Jump frequency 2U Upper limit of jump frequency 2,see 5.3.11 0.00~80.00 Hz 51.00 ○
Input voltage
coefficient
Correction coefficient of input voltage value
If the measured input voltage is smaller than the
true value, the value should be adjusted higher;
otherwise, the input voltage should be reduced
50~200 No 100 ○
Max. set current
The Max. value of given current signal at the site,
corresponding to the Max. frequency (or closed loop
control to the given quantitative 100%) Notes: When
the analog given is voltage signal, theMax. value of
a given voltage is adjusted by this parameter.
10.00~25.00 mA 20.00 ○
Min. set current
The Min. value of given current signal at the site,
corresponding to 0Hz (or closedloop control to the
given quantitative 0%) Notes: When the analog
given is voltage signal, theMax. value of a given
voltage is adjusted by this parameter.
0.00~8.00 mA 4.00 ○
DI set 1 The set frequency when PLC speed 1 closed 0.00~80.00 Hz 10.00 ○
DI set 2 The set frequency when PLC speed 2 closed 0.00~80.00 Hz 20.00 ○
DI set 3 The set frequency when PLC speed 3 closed 0.00~80.00 Hz 30.00 ○
Power loss shielding
time delay High voltage power loss occurs, time delay of
shielding failure of high voltage power loss
1~100 S 1 ◎