STB8827
Series Operation Manual
Contents
3.5 <MEASURE
SETUP>
.............................................................
24
3.5.1 Trigger
mode
............................................................ 25
3.5.2
Auto level control function .......................................... 26
3.5.3
Bias current isolation function ..................................... 26
3.5.4 Average
................................................................... 27
3.5.5 Level
monitor function ............................................... 27
3.5.6 Delay
time ............................................................... 28
3.5.7 Output
impedance .................................................... 28
3.5.8
Deviation test function ............................................... 29
3.6 <CORRECTION>
.................................................................. 30
3.6.1 OPEN
......................................................................
31
3.6.2 SHORT
....................................................................
33
3.6.3 LOAD ...................................................................... 34
3.6.4 Load
correction
test function ...................................... 35
3.6.5 Cable
length selection ............................................... 36
3.7 <LIMIT
TABLE> ................................................................... 36
3.7.1 Swap
parameter ....................................................... 37
3.7.2
Limit modes of compare function ................................ 37
3.7.3
Set nominal value of tolerance mode ........................... 39
3.7.4 Comparator
function
ON/OFF
...................................... 39
3.7.5 Auxiliary
bin ON/OFF ................................................. 39
3.7.6 HIGH/LOW
............................................................... 40
3.8 <LIST
SWEEP SETUP> ......................................................... 41
3.8.1 MODE ..................................................................... 42
3.8.2 Test
parameter ......................................................... 42
3.8.3 Sweep
parameter setup ............................................. 42
Chapter 4 [SYSTEM] and <FILE MANAGE> ............................................. 44
4.1 <SYSTEM
SETUP> ............................................................... 44
4.1.1 PASS
BEEP
............................................................... 44
4.1.2 FAIL
BEEP
................................................................
45
4.1.3 LANGUAGE .............................................................. 45
4.1.4 PASS
WORD
............................................................. 45
4.1.5
BUS MODE (Reserved function) ................................... 46
4.1.6
GPIB ADDR (Reserved function) .................................. 46
4.1.7 TALK
ONLY
............................................................... 46
4.1.8 BIAS
SRC
................................................................
47
4.1.9 BAUD
RATE .............................................................. 47
4.1.10 DATA/TIME .............................................................. 47
4.2 LCR
<FILE
MANAGE> ........................................................... 47
4.2.1
Setup file for single-group component (*.STA) .............. 48
4.2.2
U-disk manage performance ....................................... 49
4.2.3
Operation steps for file management ........................... 49
Chapter 5 Execute LCR operation and some examples ............................. 52
5.1 Correction
operation
III
............................................................. 52
