Saluki STB8827 Series, Руководство по эксплуатации

Страница: 23 / 131

STB8827 Series Operation Manual Chapter 3 Introduction to [MEAS]
17
Level voltage Resolution
50 mVrms
～
100mVrms
100 μ Vrms
100 mVrms
～
1Vrms 1mVrms
1Vrms
～
2Vrms 10mVrms
———————————————————————————————————————
Note: The measurement current is the output one when the tested
terminal is short, while the measurement voltage is the output one when
the tested terminal is open.
———————————————————————————————————————
The auto level control function of STB8827 can realize the measurement
of constant voltage or current. The auto level control function (ALC) can be set
as ON in <MEAS> page. When the auto level control function is set to ON, “*”
will be displayed following the current level value. Refer to <MEAS> for
more information.
Operation steps for setting test level:
STB8827 provides two methods to set the level of test signal source. The first
one is to use soft keys, while the second one is to input data by numeric keys.
1) Move the cursor to LEVEL, the following soft keys will be displayed.

↑
(+)
This soft key is used to increase the level of test signal source.
↓
(-)
This soft key is used to decrease

the level of test signal source.
2) Soft or numeric keys are used to select or set the test level. When numeric
keys are used to input the desired level, the available units (mV, V, µA, mA
and A) will be displayed in the soft key zone. Users can use these unit keys to
input unit and data. When [ENTER] is used to terminate the input of level, the
default level is V or A.
———————————————————————————————————————
NOTE: When you need to switch the level between current and voltage,
numeric keys and unit soft keys must be used.
———————————————————————————————————————
3.1.5 DC BIAS
STB8827 provides internal DC bias voltage from -5V to +5V. When the
test function is selected as DCR, the bias zone will display “---”.
Operation steps for setting DC bias:
STB8827 provides two methods to set the DC bias. The first one is to use soft keys,
while the second one is to input data by numeric keys.
1) Move the cursor to DC BIAS, the following soft keys will be displayed.