Tel: 886. 909 602 109 Email: [email protected]
47
Fig. 6-9 Setup of Power Level
2) Cutoff of port power
Menu path:
[Stimulus] > [Power] > [Power state ON/off]
. Or, switch the power by changing the Setup of the
[Power ON/off]
check box in the [Power Setup] dialog box.
3) Manual Setup of attenuation
Menu path:
[Stimulus] > [Power] > [Power and attenuation...]
. The
[Power and attenuation]
will appear.
Click to clear the
[Auto attenuation]
zone check box. Click the
[Attenuation]
input box and enter the attenuation
value.
4) Setup of power slope
Menu path:
[Stimulus] > [Power] > [Power...]
. The [Power] dialog box will appear. Click
[Slope]
check box.
Click the
[Slope]
input box and enter the power slope.
5) [Power] dialog box
a) [Power ON/off] check box
If this check box is ticked, the port will normally output the power. If this check box is cleared, the port output
power will be cut off.
b) [Power-port 1]
Set the power level of the port 1.
c) [Power slope] check box
Tick the
[Power slope]
check box and enter the slope value in the
[Slope]
input box to enable the power slope
function.
The power slope is used to compensate the power loss of the cable and test fixture as a result of frequency increase.
If the power slope function is enabled, the output power of the test port will increase (or decrease) with the
increase of Sweep frequency.
Содержание S3602 Series
Страница 1: ...S3602 Series Vector Network Analyzer Quick Start Guide Saluki Technology Inc...
Страница 30: ...Tel 886 909 602 109 Email sales salukitec com www salukitec com 30 Fig 3 24 Use of Torque Wrench...
Страница 33: ...Tel 886 909 602 109 Email sales salukitec com www salukitec com 33 Fig 4 4 System Recovery Screen...
