1-006
GENERAL SAFETY
Never use your hands to check for leaks when inspecting a hydraulic system. Use a piece of
cardboard and always wear gloves and safety glasses.
Get immediate medical attention if fluid has been injected under your skin. Fluid penetration from
a pin hole leak can cause severe injury or death.
Ensure that hydraulic lines and hoses are routed and fitted properly. Ensure that no connections
are interchanged. All fittings, lengths and specifications of hoses must comply with the technical
requirements.
Observe all product safety regulations when handling fuel, oils, grease, engine coolant and other
chemical substances. Be careful especially when these items are hot as there is a risk of burning
or scalding.
Operate internal combustion engines and fuel operated heating
systems only in adequately ventilated premises. Before starting the
engine in an enclosed area, make sure there is sufficient ventilation.
1-11. Transporting the Machine
Use only suitable and approved trailers and haul vehicles and lifting equipment of sufficient
capacity.
Entrust to experienced personnel the fastening and lifting of loads and instructing of crane
operators.
Only experienced persons familiar with the operation of the machine may load and unload the
machine.
Use ramps or a loading dock when loading or unloading the machine. Ramps must be the proper
strength, low angle and the proper height and width.
Block the wheels (front and rear) of the hauling vehicle when loading and unloading the
compactor. Ensure that the haul vehicle is on level ground and approach the loading ramps
squarely to make sure that the compactor does not slide off the edge of the ramp.
Keep the deck clear of mud, oil, ice or snow or other materials that can make the deck slippery.
Position the compactor on the trailer or transport vehicle centered from side to side, and apply
the brake. Shut off the engine and lock all lockable compartments.
Block the drums and lock the articulation lock bar. Chain the machine down properly using the
appropriate tackle.
Know the overall height of the compactor and hauling vehicle. Observe height and weight
regulations and be sure you can pass safely at overhead obstructions.
Obey all traffic regulations and be sure that the proper clearance flags, lights and warning signs
including “Slow Moving Vehicle” emblem are displayed when traveling on public roads.
Know the approximate stopping distance at any given speed.
Drive Safely. Never turn corners at excessive speeds.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Содержание SV400D-2
