Sakai SV400D-2, Руководство по ремонту

Страница: 16 / 218

1-004
GENERAL SAFETY
Do not work close to edges or in the vicinity of overhanging banks or on grades that could cause
the compactor to slide or roll over. Avoid any areas that may be a risk to machine stability.
Avoid side hill travel. Always operate up and down the slope. Always keep the propulsion (travel
control) lever in low speed range when climbing or descending hills or steep grades.
Make sure there is sufficient clearance when crossing underpasses, bridges and tunnels or when
passing under overhead power lines.
Never allow anyone to stand in the articulation area of the machine when the engine is running.
Always look in all directions before reversing the direction of travel.
Always switch on the lighting system (if equipped) during poor visibility conditions and after dark.
Do not attempt to control the compactor travel speed with the throttle control. Maintain engine
speed at the full operating RPM.
Do not run the engine in a closed building for an extended period of time. Exhaust fumes can kill.
1-9. Stopping
Always park the machine in a safe area on solid and level ground. If this is not possible, always
park at a right angle to the slope and block the drum(s) or tires.
Do not leave the operator’s platform with the engine running. Always move the travel lever to
neutral position and apply the parking brake then turn the starter switch to OFF.
Lock all lockable compartments.
Park behind a safe barrier, use proper flags, and warning devices, especially when parking in
areas of heavy traffic.
1-10. Maintenance
In any performing any work concerning the operation, adjustment or modification of the machine
or it’s safety devices or any work related to maintenance, inspection or repair, always follow the
start-up and shut-down procedures in the Operator’s Manual and the Maintenance Manual.
Ensure that the maintenance area is safe and secure.
If the machine is shut down for maintenance or repair work
it must be secured against inadvertent starting by removing
the starter key and attaching a warning sign to the starter
switch.
The machine must be parked on stable and level ground
with the drum or tires blocked to prevent inadvertent
movement.
Immediately after the engine has stopped, the exhaust
system, engine, radiator coolant, engine oil, hydraulic fluid
and other lubricants and components will be very hot.
Fluids can be under pressure, removing the radiator cap
or draining oil or changing filters can cause serious burns.
Wait until the machine has cooled down.
Use care when attaching and securing lifting tackle to
individual parts and large assemblies being removed
or repositioned for repair purposes to avoid the risk of
accident. Use lifting devices that are in perfect condition
and of sufficient lifting capacity. Never stand under
suspended loads.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Do not operate.
DANGER
Keep this warning tag, if not used, in tool box.
Do not operate.
DANGER
Keep this warning tag, if not used, in tool box.