P a g e 43
Running a diagnose
When you turn on the Diamond Controller it will first check the internal configuration and
memory content. If it finds a problem it will play an audio message reporting an initialization
error. Such errors might not be critical, the Diamond Controller will try to disable the corrupted
functionality so, after the error message, the board might seem to behave normally. Depending
on the severity of the error, you might get full, partial or no functionality at all.
Whenever there’s an initialization error reported, you should run the diagnose tool in order to
investigate the problem. Connect your saber to the computer, run the Ultrasabers Launcher
and press the “Diagnose” button located on the “Diamond Controller” tab.
You’ll be presented with a list of checks. For the first diagnose run you should leave everything
as it is. If the error persists and is not reported then you should run the diagnose again with all
the checks enabled; it will take longer but it will check everything.
When you press the “Run Diagnose” button, the Diamond Controller will start to run some
internal checks.
