Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 172 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-85
Horizontal Zero
The Horizontal should be set about .050” from the front of the first main to be bored, making sure that that
position will allow the head to travel up without interference. Bring the head down and roughly center it
in front of the first main. It does not need to be perfectly centered to set the horizontal zero. Press the
Horizontal Zero button at this location.
In/Out and Vertical Zero
Locate the supplied Last Word indicator and small magnetic base. Mount on cutterhead as shown below.
Using the Horizontal handwheel move the indicator inside the main bore, making sure the indicator is
not touching the main bore at this point. You will be indicating both sides and the bottom of the saddle,
generally the cap is not used to indicate from.
Physically move the indicator and mag base on the cutterhead until there is about .010” pressure on it.
Start rotating the spindle CW and CCW watching he indicator. As there is too much or too little pressure
on the indicator, use the In/Out and Vertical handwheel to adjust the spindle in the bore until all three point
are equal. Press the In/Out and Vertical zero buttons at this point.
The Vertical stops have now been set. You are finished with the Program Vertical Stops screen, select
the next Tab to the Right.