Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 121 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-34
Visually check for clearance between the cutterhead and head fixture tooling pieces, especially the head
clamp handle, assembly. The head should be approximately centered in the path of the cutterhead.
Setting Up Rottler Fly Cutting Tool With Two Inserts
• Travel the spindle to the center of the machine bed.
• Go to the Rottler home screen on the machine before proceeding.
•
Remove the cutter head shroud from the fly cutter. Attach a dial runout indicator to a cylinder head or
engine block, etc.
• Rotate cutter head and check to see that both inserts are the same distance from the center of the
spindle, within .004.
• If adjustment is necessary loosen the tool holder clamp wedge, and the height adjustment screw.
Move tool in or out the required distance. Tighten the clamp wedge. Snug up the height adjustment
screw. There is a set screw located at the bottom of the tool holder; it locks a dowel pin in place.
• When the in-out adjustment is set, loosen the set screw, the pin will pop out and hit the back of the
slot. Tighten the set screw. This way, when a tool holder is removed and then replaced, it will be
located very nearly where it was.
• Insert height will still need to be adjusted.
• Rotate cutter head and check to see that both inserts are the same height within .0015-.0003 The
closer you get it the more accurate your surface will be.
• If adjustment is necessary loosen the tool holder clamp wedge, then alternately loosen and tighten
the height adjusting screw and the retaining screw, until both inserts are set as desired.
• Retighten the tool holder clamp wedge, and recheck both inserts.