Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 164 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-77
Auto Milling
Go to the Operations Tab.
Vertical Start
Press Copy Highest next to Vertical Start. This will copy the Highest Probed point of either bank. This is
the Height at which the Start Auto Cycle would start the first cutting pass.
Vertical End
Press Copy Highest next to Vertical Start. This will copy the Highest Probed point of either bank. This is
the height at which the Start Auto Cycle would end the Final Pass. You would use this value if you just
wanted to clean the deck up to the lowest point. If you want to cut the Deck Height to a certain value you
would manually enter that value into the Vertical End Data Box.
Cut Left or Cut Right
Pressing either of these buttons will Start the Auto Cycle for only the associated bank. That bank will be
cut to the set parameters and the machine will stop.
Start Auto Cycle
Pressing this button will start the Auto Cycle for Both Banks. First the Left bank will be cut to the set
parameters. The spindle will go to the Clearance Height and Roll over to the Right bank and cut it to the
set parameters. The Spindle will again go to the Clearance Height and roll over to the Left bank. The
machine will go idle at this point.